Easy Slider Cover Lifter (1 Pair to hold one spa cover) - 

A & B Accessories ESBK

A slider makes your cover last longer through its gentle operation. Bar lifters put excessive strain on cover seams and joints by hanging the entire weight of the cover by its center seam. Our easy slider is easier to operate as the weight of the cover is supported by the spa and lifter – you aren’t required to lift the weight of the cover. 

How to Install:

Position the Easy Slider arms so the top of the arm is level with the top of the spa. Center the arms right to left allowing at least 1” clearance between the arms. Fasten to the spa cabinet with 8 each 2” screws provided making sure the uprights are plumb and the top of the arms are approximately 1/8th” higher than the top of the spa.

If your spa has a chair rail, like the Arctic Spas Classic and custom Series, you will need an additional support piece behind the cover lift.  Email to verify this is included.

How to Use: 

Fold the cover and slide onto the Easy Slider arms. They will open to hold the cover. You can do this outside the spa pulling the cover toward you or inside the spa pushing the cover onto the arms. DO NOT LIFT UP ON THE COVER while opening as this will cause the arms to close. A sliding motion works best. Slide the cover back onto the spa and the arms will close by themselves.

Note: Pictured is wood; this item is BLACK.  It is no longer available in wood.  Black is the only available color.